Hitachi ZW370, ZW370-G Wheel Loader Service Repair Manual
The manual is applicable for the Hitachi ZW370, ZW370-G Wheel Loader Model
Format: PDF
Language: English
Service Manual consists of the following:
For Model ZW370-G as mentioned above:
Service Manual (Troubleshooting) : Vol. No.TTNHB
Operation Manual : Vol. No.TONHB
Workshop Manual : Vol. No.WNHB
For Model ZW370 as mentioned above:
Service Manual (Troubleshooting) : Vol. No.TT97C5-E
Operation Manual : Vol. No.TO97C5-E
Workshop Manual : Vol. No.W97C5-E
Table of Content of the Workshop Manual
CONTENTS
General Information …. 00-1
Symbols … 00-2
Weight of Main Components ….. 00-3
Bolt Tightening Torque ….. 00-4
Hose Band Tightening Torque …… 00-8
Liquid Gasket and Screw Lock Agent … 00-9
Cautions regarding parts removal …… 00-9
Cautions regarding reassembly … 00-9
Screw lock agent application procedure … 00-10
How to wind a seal tape …. 00-10
Cautions Regarding Welding Repair Service …00-11
Cautions Regarding Handling of Bearing ….. 00-13
Bearing installation cautions … 00-13
Interference fits for a bearing ….. 00-13
Bearing removal cautions …. 00-14
Applying and Storing Articulation Stopper …. 00-15
Applying articulation stopper … 00-15
Storing articulation stopper ….. 00-16
Disassembly & Reassembly Chassis Group …… 14-1
Deck …… 14-2
Deck removing and installing …. 14-2
Fuel Tank …. 14-3
Fuel tank removing and installing …… 14-3
Hydraulic Tank ….. 14-5
Hydraulic tank removing and installing …. 14-5
Engine Room …. 14-7
Engine room removing and installing …. 14-7
Cab …. 14-9
Cab removing and installing … 14-9
Floor Board …14-11
Floor board removing and installing …..14-11
Boom … 14-13
Boom removing and installing …. 14-13
The above is only an extract of the table of content and not the whole table.
Hitachi ZAXIS ZW370, ZW370-G service manual consists of the Troubleshooting and the Workshop Manual.
- Information included in the Service Manual: Technical information needed for redelivery and delivery, operation and activation of all devices and systems, operational performance tests, and troubleshooting procedures.
- Information included in the Workshop Manual: Technical information needed for maintenance and repair of the machine, tools and devices needed for maintenance and repair, maintenance standards, and removal / installation and assemble / disassemble procedures.
Pilot valve assembling
To reassemble the pilot valve, follow the above disassembly procedure in reverse order.
Pilot valve assembly cautions
– Clean and check all the parts. If any part is defective, replace or repair it.
– Replace all the O-rings and seals with new ones.
– Apply the specified torque to tighten each main part.
– Apply a thin coat of hydraulic oil or grease to each part before reassembly.
– Measure the resistance of each coil magnet assembly.
The resistance should be 62 at normal room temperature [(20C) (70F)]. If measured in extremely low temperatures the resistance will be less, and at operating temperature the resistance will be higher.
– Be aware that the assembled parts, such as the push rod, spring, etc. are different depending on the ports. Use the correct parts.
– Insert scraper (41) in correct direction.
– Do not push push rod (37) too much with the set screw while adjusting the position of the lever (31). It may cause bumping at Neutral position, resulting in unexpected movement at starting the engine.
Reviews
There are no reviews yet.